Aquila Drilling

Aquila Rig #10 NATIONAL 1320UE
(Working in West Texas)

MAST & SUB:

ONE (1) LEE C. MOORE, 142’ HIGH CANTILEVER TYPE MAST PLUS CANTILEVER SUBSTRUCTURE, 36’ WIDE X 25’ FT. HIGH X 75’ LONG BASE, GALVANIZED, 1,000,000 LBS CAPACITY WITH 12 LINES. WIND LOAD CAPACITY 100 KNOTS, SET BACK CAPACITY 500,000 LBS AND 800,000 LBS DRILL PIPE CAPACITY SIMULTANEOUSLY, COMPLETE WITH RACKING PLATFORM. DRILLER’S AND OFF-DRILLER’S SIDE TOP DOG HOUSES, 10’W X 8’H X 30’L WITH DRILLER LOCKERS, STORAGE BOXES, KNOWLEDGE BOX

ONE (1) 18”H X 9’W X 60’L CATWALK WITH (25) 18”H X 23’L PIPE RACKS AND (2) 42”H X 28’L TRIANGULAR PIPE RACKS

DRAWWORKS:

ONE (1) NATIONAL 1320 UE, FOR 1-3/8” DRILL LINE WITH TWO (2) GENERAL ELECTRIC, GE-752, 1,000 HP DC TRACTION MOTORS, COMPLETE WITH NATIONAL MAKE-UP AND BREAK-OUT CATHEADS, OVER-RUNNING CLUTCH, AIR DRILLERS CONSOLE AND BAYLOR ELMAGCO MODEL 7838 BRAKE

ROTARY:

ONE (1) ROTARY WITH INDEPENDENT DRIVE NATIONAL, MODEL C-275, 27-1/2” ONE (1) GENERAL ELECTRIC, DC MODEL GE-752AU, 1,000 HP MOTOR WITH EMERGENCY MECHANICAL INDEPENDENT DRIVE

HOOK & BLOCK:

ONE (1) BLOCK/HOOK NATIONAL, MODEL 660-G500 (INTEGRATED), 500 TON. CAPACITY, SIX (6) 1-3/8” X 60” SHEAVES

CROWN:

ONE (1) NATIONAL MODEL 7-60-FA CROWN, 500 TON WITH 7 – 60” – 1-3/8” SHEAVES

SWIVEL:

ONE (1) NATIONAL MODEL P500, 500 TON

TRIPLEX MUD PUMPS:

TWO (2) GARDNER DENVER PZ-11, 1,600 HP TRIPLEX PUMPS WITH TWO (2) GENERAL ELECTRIC, GE-752-AUI, 1,000 HP DC TRACTION MOTORS WITH HYDRIL MODEL K-20-5000, 5,000# PULSATION DAMPNERS, ONE (1) 6”X 5” MISSION MAGNUM CENTRIFUGAL SUPERCHARGER PUMP WITH 70 HP ELECTRIC MOTOR, ONE (1) RESET RELIEF SAFETY VALVE, OILFIELD SKIDDED

GENERATORS DIESEL / AC:

THREE (3) CATERPILLAR 3512C, 1476 BHP (1101 BKW) @ 1200 RPM, 2006 EPA/CARB Non-Road mobile TIER 2 Emissions & IMO Certified WITH KATO 6P6-3300 Generator, Rated: 1365 eKw, 1950 Kva, 0.7 PF, 600 Volt, 3 phase, COMPLETE WITH GT #3681H MB Radiator, SILENCER MSA-1 WITH SPARK ARREST AND 10’W X 10’H X 30’L OILFIELD SKID WITH ROOF.

SCR:

ONE (1) SCR, ROSS HILL, MODEL 1650 WITH FOUR (4) BAYS, 1800 AMP CAPACITY, 750 VOLTS DC, WITH AC BUSS, COMPLETE UNIT. INCLUDING ONE (1) GENERAL ELECTRIC 770 LINE MOTOR CONTROL CENTER, MODEL 434X162003, 480 VOLTS, THREE PHASE, AND 60 HZ. UNIT MOUNTED IN 10’W X 10’H X 30’L TEMPERATURE CONTROLLED HOUSE WITH 8’L PORCH WITH TWO (2) TRANE AIR COND. UNITS ON OILFIELD SKID

COMPRESSOR HOUSE:

8’W X 8’H X 30’L ROUND TOP COMPRESSOR HOUSE WITH (2) MANCHESTER 200 PSI RECEIVER TANKS, (2) SULLIVAN-PALATEK, MODEL 30 DG AIR COMPRESSORS WITH 30 HP ELECTRIC MOTORS, AND (1) LEROI, MODEL 770 COLD START COMPRESSOR WITH 14.6 HP DIESEL ENGINE

FUEL TANKS:

(1) 10’W X 8’H X 35’L, 21,000 GALLON CAPACITY FUEL TANK WITH 5’L SKID EXTENSION, (2) ROPER 3611, 1”, 3HP FUEL TRANSFER PUMPS, (1) ALFA LAVAL SEPARATOR MODEL MAB-1039-24-60 WITH 1 HP MOTOR.

WATER TANKS:

(1) 10’W X 8’H X 40’L, 600 BBL WATER TANK WITH MANIFOLD AND OILFIELD SKID

(1) 10’W X 8’H X 32’L, 456 BBL WATER TANK WITH 6’L SKID EXTENSION, (2) 4” X 3” MISSION MAGNUM CENTRIFUGAL PUMPS WITH 30 HP ELECTRIC MOTORS AND OILFIELD SKID

MUD SHAKER TANK:

10’W X 8’H X 35’L, 500 BBL FLAT BOTTOM, TWO (2) COMPARTMENT TANK, INTERNAL PLUMBING, MUD JETS, 10’L COVERED PORCH WITH (2) 8” X 6” CENTRIFUGAL PUMPS WITH 75 HP MOTORS, TOP MOUNTED WALKWAYS, SAFETY RAILS, STAIRS ON OILFIELD SKID

MUD TRIP TANK:

10’W X 8’H X 10’L, 142 BBL FLAT BOTTOM, ONE (1) COMPARTMENT TRIP TANK, INTERNAL PLUMBING, MUD JETS, 8’L COVERED PORCH WITH (2) 4” X 3” CENTRIFUGAL PUMPS WITH 20 HP MOTORS, TOP MOUNTED WALKWAYS, SAFETY RAILS, STAIRS ON OILFIELD SKID

MUD INTERMEDIATE TANK:

10’W X 8’H X 43’L, 613 BBL, FLAT BOTTOM, THREE (3) COMPARTMENT TANK, INTERNAL PLUMBING, MUD JETS, (3) Inter American Pitboss 7.5 HP MUD AGITATORS, TOP MOUNTED WALKWAYS, SAFETY RAILS, STAIRS ON OILFIELD SKID

MUD SUCTION TANK:

10’W X 8’H X 35’L, 500 BBL, FLAT BOTTOM, THREE (3) COMPARTMENT TANK, INTERNAL PLUMBING, MUD JETS, 10’L COVERED PORCH WITH (2) 8” X 6” MISSION MAGNUM CENTRIFUGAL PUMPS WITH 75 HP MOTORS, (3) Inter American Pitboss 7.5 HP MUD AGITATORS, TOP MOUNTED WALKWAYS, SAFETY RAILS, STAIRS, MUD MANIFOLD, (7) 8” GATE VALVES ON OILFIELD SKID

DESILTER / DESANDER / SHAKER:

(2) BRANDT COBRA LINEAR SHALE SHAKERS

BRANDT DESANDER WITH (2) 12” CONES

Brandt DESILTER WITH (16) 4” CONES

DEGASSER:

5’ DIA. X 20’H POOR BOY STYLE DEGASSER WITH 10” FILL AND RETURN LINES, (2) 4” CHOKE MANIFOLD FLOW LINES, 10” VENT LINE ON OILFIELD SKID

STAND PIPE:

(2) STANDPIPE 5-9/16” WITH 4” Y 3” - 5,000 PSI MANIFOLD VALVES, CAMERON I.W. FLEX-SEAL

BLOW OUT PREVENTION EQUIPMENT:

CLOSING UNIT:

KOOMEY MODEL TYPE 60, 7-STATION, 120 GALLON CAPACITY WITH (12) 12 GALLON BOTTLES, (1) GASSO PQ20 TRIPLEX HYDRAULIC PUMP WITH 25-HP EXPLOSION PROOF MOTOR, (3) HYDRO MODEL309025-50-00 PNEUMATIC PUMPS, HYDRAULIC RESERVOIR, (5) RAM LOCK VALVES, TYPE BK-14500, (3) 3/4” HYDRO-PNEUMATIC REGULATOR PRESSURE VALVES, (1) 234 GALLON RESERVE TANK, (2) 10,000 PSI GAUGES, (1) 3,000 PSI GAUGE IN 10’W X 8’H X 18’L COVERED HOUSE ON OILFIELD SKID

ONE (1) 8-STATION REMOTE CLOSING UNIT LOCATED IN THE DOG HOUSE

ANNULAR PREVENTER:

CAMERON TYPE D, 13-5/8” X 5,000# HYDRAULIC ANNULAR PREVENTER

RAM PREVENTERS:

CAMERON TYPE U, 13-5/8” x 10,000# DOUBLE RAM PREVENTER

CAMERON TYPE U, 13-5/8” x 10,000# SINGLE RAM PREVENTER

CHOKE MANIFOLD:

CAMERON, 10,000 PSI WITH (8) CAMERON 4-1/16”, 10,000 PSI GATE VALVES, (1) 2-1/16”, 10,000 PSI GATE VALVES MOUNTED ON AN ADJUSTABLE SKID

LINKS:

ONE (1) SET VARCO LINKS, 2-3/4” X 108” CAPACITY 350 TONS

TOOL HOUSE:

8’W X 9’H X 30’L, ROUND TOP, TOOL HOUSE WITH CABINETS, PARTS BIN, AND WORKBENCH ON OILFIELD SKID