Aquila Drilling

Aquila Rig #8 NATIONAL 1320UE
(Working in West Texas)

MAST & SUB:

ONE (1) LEE C. MOORE, 142’ HIGH CANTILEVER TYPE MAST PLUS CANTILEVER SUBSTRUCTURE, 36’ WIDE X 25’ FT. HIGH X 75’ LONG BASE, GALVANIZED, 1,000,000 LBS CAPACITY WITH 12 LINES. WIND LOAD CAPACITY 100 KNOTS, SET BACK CAPACITY 500,000 LBS AND 800,000 LBS DRILL PIPE CAPACITY SIMULTANEOUSLY, COMPLETE WITH RACKING PLATFORM. DRILLER’S AND OFF-DRILLER’S SIDE TOP DOG HOUSES, 10’W X 8’H X 30’L WITH DRILLER LOCKERS, STORAGE BOXES, KNOWLEDGE BOX

ONE (1) 18”H X 9’W X 60’L CATWALK WITH (18) 18”H X 20’L PIPE RACKS, (10) 42”H X 28’L TRIANGULAR PIPE RACKS, AND (4) 24”H X 28’L TRIANGULAR PIPE RACKS

DRAWWORKS:

ONE (1) NATIONAL 1320 UE, FOR 1-3/8” DRILL LINE WITH TWO (2) GENERAL ELECTRIC, GE-752, 1,000 HP DC TRACTION MOTORS, COMPLETE WITH NATIONAL MAKE-UP AND BREAK-OUT CATHEADS, OVER-RUNNING CLUTCH, AIR DRILLERS CONSOLE AND BAYLOR ELMAGCO MODEL 7838 BRAKE

ROTARY:

ONE (1) NATIONAL C-275 ROTARY TABLE WITH INDEPENDENT DRIVE, 27-1/2” ONE (1) GENERAL ELECTRIC, GE-752AU, 1,000 HP DC TRACTION MOTOR WITH EMERGENCY MECHANICAL INDEPENDENT DRIVE

HOOK & BLOCK:

NATIONAL, MODEL 660-G500 (INTEGRATED), 500 TON CAPACITY WITH SIX (6) 1-3/8” X 60” SHEAVES

CROWN:

ONE (1) NATIONAL MODEL 7-60-FA CROWN, 500 TON WITH (7) – 60” – 1-3/8” SHEAVES

SWIVEL:

ONE (1) NATIONAL MODEL P500, 500 TON

TRIPLEX MUD PUMPS:

TWO (2) NATIONAL MODEL 10 P-130, 1,300 HP WITH TWO (2) GENERAL ELECTRIC, GE-752AUI, 1,000 HP TRACTION MOTORS, INCLUDING HYDRIL MODEL K-20, 5,000 PSI PULSATION DAMPNERS, ONE (1) 6” X 5” CENTRIFUGAL SUPERCHARGER PUMP AND ONE (1) RESET RELIEF SAFETY VALVE WITH OILFIELD SKID

GENERATORS DIESEL / AC:

THREE (3) CATERPILLAR 3512C, 1476 BHP (1101 BKW) @ 1200 RPM, 2006 EPA/CARB Non-Road mobile TIER 2 Emissions & IMO Certified WITH KATO 6P6-3300 Generator, Rated: 1365 eKw, 1950 Kva, 0.7 PF, 600 Volt, 3 phase, COMPLETE WITH GT #3681H MB Radiator, SILENCER MSA-1 WITH SPARK ARREST AND 10’W X 10’H X 30’L OILFIELD SKID WITH ROOF.

TWO (2) SULLIVAN PALATEK MODEL 30DG AIR COMPRESSORS WITH 30 HP ELECTRIC MOTORS, RADIATORS, HORIZONTAL RECEIVER TANKS MOUNTED ON SKIDS ONE AND TWO AND ONE (1) LEROI MODEL 770 cold start compressor, diesel powered, MOUNTED ON SKID THREE

SCR:

ONE (1) SCR, ROSS HILL, MODEL 1650 WITH FOUR (4) BAYS, 1800 AMP CAPACITY, 750 VOLTS DC, WITH AC BUSS, COMPLETE UNIT. INCLUDING ONE (1) GENERAL ELECTRIC 770 LINE MOTOR CONTROL CENTER, MODEL 434X162003, 480 VOLTS, THREE PHASE, AND 60 HZ. UNIT MOUNTED IN 10’W X 10’H X 30’L TEMPERATURE CONTROLLED HOUSE WITH 9’L PORCH WITH TWO (2) TRANE AIR COND. UNITS ON OILFIELD SKID

FUEL TANK:

ONE (1) 8’ DIA. X 32’L, 300BBL FUEL TANK CONSISTING OF (2) 16’ LONG CYLINDRICAL TANKS WITH (2) 1-1/2”, 3 HP FUEL TRANSFER PUMPS, SKIDDED.

ONE (1) 8’ DIA. X 32’L, 300BBL FUEL TANK CONSISTING OF (2) 16’ LONG CYLINDRICAL TANKS ON OILFIELD SKID

WATER TANKS:

ONE (1) 10’W X 8’H X 40’L, 570 BBL OPEN TOP TANK WITH 9’L SKID EXTENSION.

ONE (1) 8’ DIA. X 16’ L, 150 BBL TANK WITH 11’ SKID EXTENSION WITH TWO (2) 4” X 3” MISSION CENTRIFUGAL PUMPS WITH 30 HP EXPLOSION PROOF ELECTRIC MOTORS ON OILFIELD SKID

MUD SHAKER TANK:

10’ W X 7’ HIGH X 35’ L, 410 BBL FLAT BOTTOM TANK, INTERNAL PLUMBING, MUD JETS WITH (2) 4’L COVERED PORCHES WITH (2) 8” X 6” CENTRIFUGAL PUMPS WITH 75 HP ELECTRIC MOTORS, TOP MOUNTED WALKWAY, SAFETY RAILING, STAIRS ON OILFIELD SKID

MUD TRIP TANK:

ONE (1) 10’W X 7’H X 12’L, 150 BBL, FLAT BOTTOM TRIP TANK WITH 7’L PORCH WITH (2) 4” X 3” MISSION MAGNUM CENTRIFUGAL PUMPS WITH 30 HP MOTORS, TOP MOUNTED WALKWAY, SAFETY RAILING, STAIRS ON OILFIELD SKID

MUD INTERMEDIATE TANK:

10’W X 7’H X 40’L, 500 BBL, FLAT BOTTOM , TWO (2) COMPARTMENT TANK, INTERNAL PLUMBING, MUD JETS, (2) MUD AGITATORS WITH 20 HP MOTORS, TOP MOUNTED WALKWAY, SAFETY RAILING, STAIRS ON OILFIELD SKID

MUD SUCTION TANK:

8’W X 7’H X 38’L, 500 BBL, TWO (2) COMPARTMENT TANK, INTERNAL PLUMBING, MUD JETS, WITH (2) 4’L COVERED PORCHES, (2) MUD AGITATORS WITH 20 HP MOTORS, (2) 8” X 6” CENTRIFUGAL PUMPS WITH 75 HP ELECTRIC MOTORS, TOP MOUNTED WALKWAY, SAFETY RAILING, STAIRS ON OILFIELD SKID

DESILTER / DESANDER / SHAKER:

BRANDT DESILTER WITH (16) 4” CONES

BRANDT DESANDER WITH (2) 12” CONES

TWO (2) BRANDT COBRA SHAKERS

STAND PIPE:

(2) STANDPIPE 5-9/16” WITH 4” Y 3” - 5,000 PSI MANIFOLD VALVES, CAMERON I.W. FLEX-SEAL

BLOW OUT PREVENTION EQUIPMENT:

CLOSING UNIT:

ONE (1) CAMERON CLOSING UNIT, SIX (6) STATION, 120 GALLON CAPACITY WITH (6) 20 GALLON BOTTLES, (1) GASSO PQ20 TRIPLEX HYDRAULIC PUMP WITH 20-HP EXPLOSION PROOF MOTOR, (2) PNEUMATIC PUMPS, HYDRAULIC RESERVOIR (6) RAM LOCK VALVES, TYPE BK-14500, (3) 3/4” HYDRO-PNEUMATIC REGULATOR PRESSURE VALVES, (1) 234 GALLON RESERVE TANK, (2) 10,000 PSI GAUGES, (1) 3,000 PSI GAUGE ON COVERED OILFIELD SKID

ONE (1) 6-STATION REMOTE CLOSING UNIT LOCATED IN THE DOG HOUSE

ANNULAR PREVENTER:

HYDRIL TYPE GK - 13-5/8” X 5,000# ANNULAR PREVENTER

RAM PREVENTERS:

CAMERON TYPE U, 13-5/8” x 10,000# DOUBLE RAM PREVENTER

CAMERON TYPE U, 13-5/8” x 10,000# SINGLE RAM PREVENTER

CHOKE MANIFOLD:

VALCON, 10,000 PSI WITH (2) VALCON 4-1/16”, 10,000 PSI GATE VALVES, (5) VALCON 2-1/16”, 10,000 PSI GATE VALVES MOUNTED ON AN ADJUSTABLE SKID

LINKS:

ONE (1) SET VARCO LINKS 2-3/4” x 108” CAPACITY 350 TONS.

TOOL HOUSE:

7’W X 7’H X 30’L TOOL HOUSE WITH CABINETS AND PARTS BIN ON OILFIELD SKID.